Search results
Results from the WOW.Com Content Network
AC voltage conversion uses a transformer. Conversion from one DC voltage to another requires electronic circuitry (electromechanical equipment was required before the development of semiconductor electronics), like a DC-DC converter. [1] Mains power (called household current in the US) is universally AC. [2]
A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [ 2 ] [ 3 ] A typical multimeter can measure voltage , resistance , and current , [ 4 ] in which case can be used as a voltmeter , ohmmeter , and ammeter .
The volt-ampere (SI symbol: VA, [1] sometimes V⋅A or V A) is the unit of measurement for apparent power in an electrical circuit. It is the product of the root mean square voltage (in volts) and the root mean square current (in amperes). [2] Volt-amperes are usually used for analyzing alternating current (AC) circuits.
Ammeters are designed for a low voltage drop across their terminals, much less than one volt; the extra circuit losses produced by the ammeter are called its "burden" on the measured circuit(I). Ordinary Weston-type meter movements can measure only milliamperes at most, because the springs and practical coils can carry only limited currents.
In electrical engineering, power conversion is the process of converting electric energy from one form to another. A power converter is an electrical device for converting electrical energy between alternating current (AC) and direct current (DC). It can also change the voltage or frequency of the current.
Since power is defined as the product of current and voltage, the ampere can alternatively be expressed in terms of the other units using the relationship I = P/V, and thus 1 A = 1 W/V. Current can be measured by a multimeter, a device that can measure electrical voltage, current, and resistance.
For example, a meter with a sensitivity of 1000 ohms per volt would draw 1 milliampere at full scale voltage; if the full scale was 200 volts, the resistance at the instrument's terminals would be 200 000 ohms and at full scale, the meter would draw 1 milliampere from the circuit under test. For multi-range instruments, the input resistance ...
Easy conversion to voltage using a resistor. Loop-powered "I to P" (current to pressure) converters can convert the 4–20 mA signal to a 3–15 psi pneumatic output for control valves, allowing easy integration of 4–20 mA signals into existing pneumatic plant.