enow.com Web Search

  1. Ads

    related to: bathroom faucet flow rate chart

Search results

  1. Results from the WOW.Com Content Network
  2. Low-flow fixtures - Wikipedia

    en.wikipedia.org/wiki/Low-flow_fixtures

    Faucets that meet energy efficiency standards for WaterSense mustn’t use more than 1.5 gpm, a 32% decrease in flow rate over the federal requirement. [8] Reduced flow faucets often make use of flow restrictors or faucet aerators to reduce the flowrate of the water. Using a faucet with an aerator results in an average 42% reduction in water ...

  3. Residential water use in the U.S. and Canada - Wikipedia

    en.wikipedia.org/wiki/Residential_water_use_in...

    Water flowing through opened faucets (including kitchen, bathroom, utility sink faucets, and hose bibs) accounts for 19 percent (26.3 gphd, or 100 lphd) of total indoor water use in an average household where faucets are used 51 times per day. On average, faucets are opened for 30 seconds at a flow of 1 gpm (gallons per minute) and an average ...

  4. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    In plumbing, a Fixture Unit (FU) or Drain Fixture Unit (DFU) is "a unit of measure, based on the rate of discharge, time of operation and frequency of use of a fixture, that expresses the hydraulic load imposed by that fixture on the sanitary plumbing installation". [1] A Fixture Unit is not a flow rate unit but a design factor.

  5. Thermostatic mixing valve - Wikipedia

    en.wikipedia.org/wiki/Thermostatic_mixing_valve

    High flow rates (from 14 to 51 US gallons per minute (53 to 193 L/min) at 45 pounds per square inch (3.1 bar)) Temperature stability; Point-of-Use. These are single Outlet Thermostatic Mixing Valves, often called "thermostatic faucets", "thermostat taps" or "thermostat valves".

  6. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Its rate is independent of the viscosity or temperature of the fluid or gas in the pipe, and depends only weakly on the supply pressure, so that flow rate is stable at a given setting. At intermediate flow settings the pressure at the valve restriction drops nearly to zero from the Venturi effect ; in water taps, this causes the water to boil ...

  7. Faucet aerator - Wikipedia

    en.wikipedia.org/wiki/Faucet_aerator

    When an aerator is added to the faucet (or fluid stream), there is a region of high pressure created behind the aerator. Because of the higher pressure behind the aerator and the low pressure in front of it (outside the faucet), due to Bernoulli's principle there is an increase in velocity of the fluid flow.

  1. Ads

    related to: bathroom faucet flow rate chart