Search results
Results from the WOW.Com Content Network
Each bit of the RC-5 code word contains 32 carrier pulses, and an equal duration of silence, so the bit time is 64×27.778 μs = 1.778 ms, and the 14 symbols (bits) of a complete RC-5 code word take 24.889 ms to transmit. The code word is repeated every 113.778 ms (4096 ÷ 36 kHz) as long as a key remains pressed.
A JP1 Remote Control. A JP1 remote is a type of universal remote, usually with a six-pin interface connector labeled "JP1" in the battery compartment, manufactured by Universal Electronics Inc. The JP1 interface allows the remote to be reprogrammed, adding new code lists and functions. Home theater hobbyists use JP1 to avoid obsolescence.
Harmony 670, a universal remote. A universal remote is a remote control that can be programmed to operate various brands of one or more types of consumer electronics devices. . Low-end universal remotes can only control a set number of devices determined by their manufacturer, while mid- and high-end universal remotes allow the user to program in new control codes to the re
Simple remote control systems use a fixed code word; the code word that opens the gate today will also open the gate tomorrow. An attacker with an appropriate receiver could discover the code word and use it to gain access sometime later. More sophisticated remote control systems use a rolling code (or hopping code) that changes for every use.
The code could also be entered into a dedicated remote control device that would then control the VCR. The number is generated by an algorithm from the date, time and channel of the programme; as a result, it does not rely on an over-the-air channel to serve as a conduit to ensure the recording is properly timed.
A remote terminal unit (RTU) is a microprocessor-controlled electronic device that interfaces objects in the physical world to a distributed control system or SCADA (supervisory control and data acquisition) system by transmitting telemetry data to a master system, and by using messages from the master supervisory system to control connected objects. [1]
Key Code Qualifier is an error-code returned by a SCSI device. When a SCSI target device returns a check condition in response to a command , the initiator usually then issues a SCSI Request Sense command .
Turbo coding is an iterated soft-decoding scheme that combines two or more relatively simple convolutional codes and an interleaver to produce a block code that can perform to within a fraction of a decibel of the Shannon limit.