Search results
Results from the WOW.Com Content Network
When the well has been drilled, it is completed to provide an interface with the reservoir rock and a tubular conduit for the well fluids. The surface pressure control is provided by a Christmas tree, which is installed on top of the wellhead, with isolation valves and choke equipment to control the flow of well fluids during production.
In subsurface hydrogeology, drawdown is the reduction in hydraulic head observed at a well in an aquifer, typically due to pumping a well as part of an aquifer test or well test. In surface water hydrology and civil engineering, drawdown refers to the lowering of the surface elevation of a body of water, the water table, the piezometric surface ...
Water pumping stations are differentiated from wastewater pumping stations in that they do not have to be sized to account for high peak flow rates. They have five general categories: [3] Source (such as a well) pump discharging into an elevated tank; Raw water pumping from a river or lake; In-line booster pumping into an elevated tank
The installation, maintenance and repair of deep well hand pumps is more complicated than with other hand pumps. A deep well hand pump theoretically has no limit to which it can extract water. In practice, the depth is limited by the physical power a human being can exert in lifting the column of water, which is around 30 m
In a completed well, there may be many annuli. The 'A' annulus is the void between the production tubing and the smallest casing string. The 'A' annulus can serve a number of crucial tasks, including gas lift and well kills. A normal well will also have a 'B' and frequently a 'C' annulus, between the different casing strings.
The three water injection pumps each had a capacity of 221 m 3 /hr with a differential head of 2068.5 metres (209 bar). The pumps discharged to the 3,000 psi manifold and wellheads. The single water injection booster pump (221 m 3 /hr, 1,379 m (139 bar) differential head) took its suction from the discharge of the water injection pumps and ...
Example Number 3: A well or bore running at 70 degrees Celsius (158F) with an operating level of 5 metres below the intake, minus a 2 metre friction loss into pump (pipe loss), minus the NPSH R curve (say 2.4 metres) of the pre-designed pump, minus a temperature loss of 3 metres/10 feet = an NPSH A (available) of (negative) -12.4 metres.
A diagram of a pumpjack. A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1] It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface. The arrangement is often used for onshore wells. Pumpjacks are common in oil-rich areas.