Search results
Results from the WOW.Com Content Network
By means of a light intensity sensor ( photoresistor, photodiode, phototransistor, etc.) that detects the amount of light that illuminates an environment, it triggers an electrical circuit that opens or closes the contacts of a mechanical relay or of a solid state relay. (power transistor, thyristor, triac, etc.), which activates the lighting ...
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
Three photoresistors with scale in mm Large CdS photocell from a street light. A photoresistor is less light-sensitive than a photodiode or a phototransistor.The latter two components are true semiconductor devices, while a photoresistor is a passive component that does not have a PN-junction.
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
Conceptual through-beam system to detect unauthorized access to a secure door. If the beam is interrupted, the detector triggers an alarm. A photoelectric sensor is a device used to determine the distance, absence, or presence of an object by using a light transmitter, often infrared, and a photoelectric receiver.
Contacts may be operated by humans in push-buttons and switches, by mechanical pressure in sensors or machine cams, and electromechanically in relays. The surfaces where contacts touch are usually composed of metals such as silver or gold alloys [ 3 ] [ 4 ] that have high electrical conductivity , wear resistance, oxidation resistance and other ...
A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...
A solid-state contactor is a heavy-duty solid state relay, including the necessary heat sink, used where frequent on-off cycles are required, such as with electric heaters, small electric motors, and lighting loads. There are no moving parts to wear out and there is no contact bounce due to vibration.