enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Orthotropic deck - Wikipedia

    en.wikipedia.org/wiki/Orthotropic_deck

    From 1982 to 1986, the original bridge deck, in 747 sections, was replaced with lighter, stronger orthotropic steel deck panels over 401 nights without closing the roadway completely to traffic. [5] The project not only restored the bridge to prime condition but also reduced the deck weight by 12,300 tons (11,160 metric tons ).

  3. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  4. CDMA2000 - Wikipedia

    en.wikipedia.org/wiki/CDMA2000

    CDMA2000 1X (IS-2000), also known as 1x and 1xRTT, is the core CDMA2000 wireless air interface standard.The designation "1x", meaning 1 times radio transmission technology, indicates the same radio frequency (RF) bandwidth as IS-95: a duplex pair of 1.25 MHz radio channels. 1xRTT almost doubles the capacity of IS-95 by adding 64 more traffic channels to the forward link, orthogonal to (in ...

  5. Plate girder bridge - Wikipedia

    en.wikipedia.org/wiki/Plate_girder_bridge

    In the deck-type bridge, a wood, steel or reinforced concrete bridge deck is supported on top of two or more plate girders, and may act compositely with them. In the case of railroad bridges, the railroad ties themselves may form the bridge deck, or the deck may support ballast on which the track is laid.

  6. Gusset plate - Wikipedia

    en.wikipedia.org/wiki/Gusset_plate

    Gusset plates are usually either made from cold-rolled or galvanized steel, based upon their use. Galvanized steel offers more protection from rust, so this is usually used when the gusset plate is exposed to the elements. The gusset plate is usually painted to match nearby steel and fixtures and to give it an extra layer of protection. [2]

  7. Deck (bridge) - Wikipedia

    en.wikipedia.org/wiki/Deck_(bridge)

    The various parts of a truss bridge. A deck is the surface of a bridge. A structural element of its superstructure, it may be constructed of concrete, steel, open grating, or wood. Sometimes the deck is covered by a railroad bed and track, asphalt concrete, or other form of pavement for ease of vehicle crossing.

  8. Falsework - Wikipedia

    en.wikipedia.org/wiki/Falsework

    Stringer: Steel beam that ties caps together Top cap: Steel Beam Post: steel pipe or 12×12 lumber. Bottom cap: steel beam Wedge pack: 4×4 lumber cut into wedges for falsework adjustment, various lumber sizes include 2×6s and plywood Corbel: distribute load to pads. Typical material is 12×12 lumber and steel beams Pad: distribute load to ground.

  9. Tongmai Special Bridge - Wikipedia

    en.wikipedia.org/wiki/Tongmai_Special_Bridge

    The second Tongmai Bridge incident occurred on August 2, 2013, when the rivet cables detached, leading to the failure of the bridge deck. Following 40 days of rigorous work, traffic successfully resumed on the morning of September 10, 2013. On the morning of January 26, 2015, traffic was halted due to the displacement of the steel frame ...