Search results
Results from the WOW.Com Content Network
The Model 1208 is also a short-barreled variant of the Model 1216. Its barrel length is 10", its overall length is 24 1/2", and its magazine can hold 8 rounds (4 x 2 shells). The Model 1208 also has a barrel shorter than 18 and is therefore also regulated by the NFA as a short-barreled shotgun.
The Remington Model 11-48 is a semi-automatic shotgun manufactured by Remington Arms as the first of its "new generation" semi-automatics produced after World War II. [1] Released as the replacement for the Remington Model 11 , it was manufactured from 1949 to 1968 and was produced in 12, 16, 20 and 28 gauge and .410 variations.
Military use of combat shotguns through the 20th century has created a need for ammunition maximizing the combat effectiveness of such weapons within the limitations of international law. 12-gauge has been widely accepted as an appropriate bore diameter to provide an effective number of projectiles within an acceptable recoil.
Designed by Wayne Leek and Robert Kelley, [2] [3] the Remington Model 1100 was introduced in 1963 as a successor to the Model 58 and Model 878 gas operated shotguns. [4] The Model 58 had supplanted the recoil operated Model 11-48, which retained the long recoil action of John Browning's original design, present in the Model 11 and the Browning Auto-5.
Some Model 11-87 shotguns, especially those with barrels shorter than 26 inches (66 cm), or Magnum models, may have issues cycling light target and birdshot loads consistently. [ citation needed ] A 12 gauge model that accepts 3 + 1 ⁄ 2 -inch (8.9 cm) shells is marketed as the Super Magnum. [ 1 ]
The Model 58 was produced in several version and grades, including a magnum version which could accept 3-inch (7.6 cm) shells, and versions with rifle sights ("Rifled Slug Specials"). [3] The Model 878 was introduced in 1959 with an improved "self-adjusting" gas system, offered in 12 gauge only. [ 4 ]
The .410 bore is the smallest shotgun size which is widely available commercially in the United States. For size comparison purposes, the .410, when measured by gauge, would be around 67- or 68-gauge (it is 67.62-gauge), The .410 is often mistakenly assigned 36-gauge. The 36 gauge had a 0.506" bore. Reloading components are still available.
Since shotgun shells are nearly twice as wide as 7.62×39mm cartridge, the extraction port in the side of the dust cover had to be increased in size. However, since the bolt had to remain the same length to fit inside the AK-47 sized receiver, the rear section of the bolt is covered by a sliding metal flap that rides on the recoil spring.