Search results
Results from the WOW.Com Content Network
A motorcycle transmission is a transmission created specifically for motorcycle applications. They may also be found in use on other light vehicles such as motor tricycles and quadbikes , go-karts , offroad buggies, auto rickshaws , mowers, and other utility vehicles, microcars , and even some superlight racing cars.
The SR400 has an air-cooled 4-stroke single cylinder SOHC 2-valve engine with a dry-sump, with the downtubes of the motorcycle's frame serving as the engine's oil reservoir and cooling system, [6] thereby eliminating the need for an external oil cooler, reducing engine pumping losses, and allowing increased ground clearance as well as reduced ...
All three were very expensive with only modest performance resulting in low sales. The original model was the S7 (the "Tourer") (2,104 produced from 1946 to 1948), in 1949 the S7 was updated to become the S7 de luxe (5,554 produced) and the S8 (8,530 produced). Both had new cylinder linings, redesigned frames and increased oil capacity.
Breakdown of VIIs under shear is a concern in motorcycle applications, where the transmission may share lubricating oil with the motor. For this reason, motorcycle-specific oil is sometimes recommended. [18] The necessity of higher-priced motorcycle-specific oil has also been challenged by at least one consumer organization. [19]
Commercial vehicle transmission diagram showing the gear fork, gearbox, and gears. Trained drivers of vehicles with non-synchronous transmissions sometimes use the techniques listed below. If improperly implemented, these techniques can cause damage to the vehicle or the loss of control of the vehicle.
The first flat-twin motorcycle engine was built in 1905 by the Light Motors Company in the United Kingdom. Originally named the Fée (renamed "Fairy" soon after its introduction), [ 15 ] it was designed as a "bicycle engine system" which transmitted power to a pulley on the rear wheel via a chain. [ 16 ]
This street-able version is also referred to as the east coast set up as Tri-cor was the east coast distributor and typically had ordered their TR6SC bikes with all the running lights and street trim. The electrics changed to 12 volts, and a bigger 6-pint oil tank was added. The front brake drum was redesigned to allow a larger braking surface ...
Total face width is the actual dimension of a gear blank including the portion that exceeds the effective face width, or as in double helical gears where the total face width includes any distance or gap separating right hand and left hand helices. For a cylindrical gear, effective face width is the portion that contacts the mating teeth.