Search results
Results from the WOW.Com Content Network
Half hitch – simple overhand knot, where the working end of a line is brought over and under the standing part; Half-Windsor knot – knot used for tying neckties; Halter hitch – connects a rope to an object; Halyard bend – a way to attach the end of a rope at right angle to a cylindrical object; Hammock hitch
A bight is a slack part in the middle of a rope, usually a curve or loop. [1] [2] Knots that can be tied without access to either end of the rope are called knots in the bight. To tie a knot with a bight is to double up the rope into a bight and then tie the knot using the double rope.
A secure, jam-proof hitch used to tie one rope to another, or a rope to a pole, boom, spar, etc., when the pull is lengthwise along the object. Ground-line hitch: A type of knot used to attach a rope to an object. Half hitch: A simple overhand knot, where the working end of a line is brought over and under the standing part. Halter hitch
Knot board [] on Elbe 1 (ship, 1965). A knot is an intentional complication in cordage [1] which may be practical or decorative, or both. Practical knots are classified by function, including hitches, bends, loop knots, and splices: a hitch fastens a rope to another object; a bend fastens two ends of a rope to each another; a loop knot is any knot creating a loop; and splice denotes any multi ...
A mnemonic used to teach the tying of the bowline is to imagine the working end of the rope as a rabbit. 1,2 – a loop is made into the standing part which will act as the rabbit's hole; 3 – the "rabbit" comes up the hole, 4 – goes round the tree (standing part) right to left; 5 – and back down the hole
[1] [2] A becket hitch has the same structure as the sheet bend, which joins, or "bends", the ends of two ropes together. The becket hitch, in contrast, fixes a rope to a closed eye or hook. [3] In this instance, a becket means the eye or hook of a pulley block, an eye in the end of a rope, or a rope handle on a sailor's sea chest.
The cowboy bowline has the working end go around the standing part on the side closer to the loop and results with the working end outside the loop. In contrast, a regular bowline has the working end finishing inside the loop. (The "rabbit" goes around the "tree" in the opposite direction from normal.)
Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length. Long splice – A splice used to join two rope ends forming one rope the length of the total of the two ropes.