Search results
Results from the WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
[a] As the tire RPM at maximum speed is not the same as the engine RPM at that power, a transmission is used with a gear ratio to convert one to the other. [b] At even slightly lower speeds than maximum, the total drag on the vehicle is considerably less, and the engine needs to deliver this greatly reduced amount of power.
Crawl ratio is a term used in the automotive world to describe the highest gear ratio that a vehicle is capable of. Note that gear ratio, also known as speed ratio, of a gear train is defined as the ratio of the angular velocity of the input gear to the angular velocity of the output gear, and thus a higher gear ratio implies a larger speed reduction, i.e. the input speed is reduced more at ...
A cycloidal drive or cycloidal speed reducer is a mechanism for reducing the speed of an input shaft by a certain ratio. Cycloidal speed reducers are capable of relatively high ratios in compact sizes with very low backlash. [1] The input shaft drives an eccentric bearing that in turn drives the cycloidal disc in an eccentric, cycloidal motion ...
The engine pressure ratio (EPR) is the total pressure ratio across a jet engine, measured as the ratio of the total pressure at the exit of the propelling nozzle divided by the total pressure at the entry to the compressor. [1] Jet engines use either EPR or compressor/fan RPM as an indicator of thrust. [2]
The gear range is difference between the highest and lowest gear ratios and may be expressed as a percentage (e.g., 500%) or as a ratio (e.g., 5:1). Heel [ edit ]
Gear inches is one way of measuring the gear ratio(s) of a bicycle, so that different gears and different bicycles can be compared in a consistent manner. Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent ( direct-drive ) gearing.
N = bearing speed. This is the maximum amount of revolutions per minute (RPM) that the bearing will move. The DN factor of a bearing is obtained by multiplying the median diameter (A + B)/2 by RPM, and sometimes by a correction factor. [2] [6] This correction factor may vary from manufacturer to manufacturer.