Search results
Results from the WOW.Com Content Network
A wireless network interface controller may be implemented as an expansion card and connected using PCI bus or PCIe bus, or connected via USB, PC Card, ExpressCard, Mini PCIe or M.2. The low cost and ubiquity of the Wi-Fi standard means that many newer mobile computers have a wireless network interface built into the motherboard.
Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
Wireless devices, BPL, and modems may produce a higher line rate or gross bit rate, due to error-correcting codes and other physical layer overhead. It is extremely common for throughput to be far less than half of theoretical maximum, though the more recent technologies (notably BPL) employ preemptive spectrum analysis to avoid this and so ...
The document defines a standard connector (AMP* 3-179397-0), mechanical elements including several form factors, and electrical interface. The 30-pin connector carries power, several audio channels and AC-Link serial data. Up to two AC'97 codecs are supported on such a card. Several form factors are specified: 45 × 27 mm; 45 × 37 mm
Category 4 cable (Cat 4) is a cable that consists of eight copper wires arranged in four unshielded twisted pairs (UTP) supporting signals up to 20 MHz. [1] It is used in telephone networks which can transmit voice and data up to 16 Mbit /s.
For example, the United States National Electrical Code, Table 310.15(B)(16), specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30 °C, the conductor surface temperature allowed to be 75 °C. A single insulated conductor ...
Allows more flexible motherboard design, component positioning and shape. Can be smaller than regular microATX. Mini-ITX: VIA: 2001 170 × 170 mm max (6.7 × 6.7 in) A small, highly integrated form factor, designed for small devices such as thin clients and set-top boxes. Nano-ITX: VIA 2003 120 × 120 mm (4.7 × 4.7 in)