enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Thermoelectric generator - Wikipedia

   en.wikipedia.org/wiki/Thermoelectric_generator

   Thermoelectric generators are used in stove fans. They are put on top of a wood or coal burning stove. The TEG is sandwiched between 2 heat sinks and the difference in temperature will power a slow-moving fan that helps circulate the stove's heat into the room. [43]

3. Profile gauge - Wikipedia

   en.wikipedia.org/wiki/Profile_gauge

   A contour gauge set to the profile of a small pot A contour gauge. A profile gauge or contour gauge is a tool for recording the cross-sectional shape of a surface. Contour gauges consist of a set of steel or plastic pins that are set tightly against one another in a frame which keeps them in the same plane and parallel while allowing them to move independently, perpendicularly to the frame.

4. Heat flux sensor - Wikipedia

   en.wikipedia.org/wiki/Heat_flux_sensor

   An example of a sensor sensitive to radiative as well as convective heat flux is a Gardon or Schmidt–Boelter gauge, used for studies of fire and flames. The Gardon must measure convection perpendicular to the face of the sensor to be accurate due to the circular-foil construction, while the wire-wound geometry of the Schmidt-Boelter gauge can ...

5. Fan heater - Wikipedia

   en.wikipedia.org/wiki/Fan_heater

   Portable fan heater A Japanese kerosene fan heater that burns kerosene for fuel. It contains an electric fan and computer controls. Electric fan heater. A fan heater, also called a blow heater, is a heater that works by using a fan to pass air over a heat source (e.g. a heating element). [1]

6. Thermal management (electronics) - Wikipedia

   en.wikipedia.org/wiki/Thermal_management...

   CPU heat sink with fan attached A heat sink (aluminium) incorporating a heat pipe (copper) All electronic devices and circuitry generate excess heat and thus require thermal management to improve reliability and prevent premature failure. The amount of heat output is equal to the power input, if there are no other energy interactions. [1]

7. Marking gauge - Wikipedia

   en.wikipedia.org/wiki/Marking_gauge

   Stanley and Veritas marking gauges. A marking gauge, also known as a scratch gauge, [1] is used in woodworking and metalworking to mark out lines for cutting or other operations. [2] The purpose of the gauge is to scribe a line parallel to a reference edge or surface. It is used in joinery and sheetmetal operations.