Search results
Results from the WOW.Com Content Network
Preselector gearboxes were most common prior to the widespread adoption of the automatic transmission, so they were considered in comparison to the "crash gearbox" type of manual transmission. Preselector gearboxes were often marketed as "self-changing" gearboxes, [ 1 ] however this is an inaccurate description as the driver is required to ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
Three-speed sliding-gear non-synchronous transmission Non-synchronous "crash" gearbox; commonly used today in semi-trucks and tractors, and formerly used in automobiles pre-1950s. A non-synchronous transmission, also called a crash gearbox, is a form of manual transmission based on gears that do not use synchronizing mechanisms. They require ...
The Multimode Manual Transmission has the following gears: R, N, E, M+, M−. R: R is the reverse gear. It is similar to R in both traditional manual and in fully automatic cars. N: N is the neutral gear. It is similar to N in both traditional manual and full automatic. E: E is the functional equivalent of D in a full automatic.
The AY-6 is a 6-speed manual transmission manufactured by Aisin. It is designed for longitudinal engine applications and can handle up to 345 ft·lbf (468 N·m) of torque. General Motors used the AY-6 as RPO MV1, MV5, and MV7.
The Saturn MP Transmission were a series of 5-speed manual and 4-speed automatic transmissions that were manufactured by Saturn Corporation exclusively for the S-Series.They were designed for transverse engine applications and was deployed in vehicles that output up to 122 ft·lbf of engine torque.
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...