Search results
Results from the WOW.Com Content Network
The Nyquist plot for () = + + with s = jω.. In control theory and stability theory, the Nyquist stability criterion or Strecker–Nyquist stability criterion, independently discovered by the German electrical engineer Felix Strecker [] at Siemens in 1930 [1] [2] [3] and the Swedish-American electrical engineer Harry Nyquist at Bell Telephone Laboratories in 1932, [4] is a graphical technique ...
Early uses of the term Nyquist frequency, such as those cited above, are all consistent with the definition presented in this article.Some later publications, including some respectable textbooks, call twice the signal bandwidth the Nyquist frequency; [6] [7] this is a distinctly minority usage, and the frequency at twice the signal bandwidth is otherwise commonly referred to as the Nyquist rate.
Nyquist stability criterion; Routh–Hurwitz stability criterion; Vakhitov–Kolokolov stability criterion; Barkhausen stability criterion; Stability may also be determined by means of root locus analysis. Although the concept of stability is general, there are several narrower definitions through which it may be assessed: BIBO stability ...
Nyquist criterion may refer to: Nyquist stability criterion, a graphical technique for determining the stability of a feedback control system; Nyquist frequency, ½ of the sampling rate of a discrete signal processing system; Nyquist rate, a rate used in signal processing; Nyquist ISI criterion, a condition to avoid intersymbol interference
Fig 1: Typical example of Nyquist frequency and rate. They are rarely equal, because that would require over-sampling by a factor of 2 (i.e. 4 times the bandwidth). In signal processing , the Nyquist rate , named after Harry Nyquist , is a value equal to twice the highest frequency ( bandwidth ) of a given function or signal.
where f C is the cutoff or corner frequency of the amplifier: in this example f C = 10 4 Hz, and the gain at zero frequency A 0 = 10 5 V/V. The figure shows that the gain is flat out to the corner frequency and then drops. When feedback is present, the so-called closed-loop gain, as shown in the formula of the previous section, becomes
Johnson–Nyquist noise, thermal noise; Nyquist stability criterion, in control theory Nyquist plot, signal processing and electronic feedback; Nyquist–Shannon sampling theorem, fundamental result in the field of information theory Nyquist frequency, digital signal processing; Nyquist rate, telecommunication theory
In nonlinear control and stability theory, the circle criterion is a stability criterion for nonlinear time-varying systems. It can be viewed as a generalization of the Nyquist stability criterion for linear time-invariant (LTI) systems .