Search results
Results from the WOW.Com Content Network
Approximately 8 acres (32,000 m 2) of soil was contaminated by wood with arsenic, chromium, and polycyclic aromatic hydrocarbons. 8% of Portland cement was used by wet weight of contaminated soil. Both in situ and ex situ processes were utilized to treat over 35,000 cubic meters of contaminated soil.
Soil vapor extraction (SVE) is a physical treatment process for in situ remediation of volatile contaminants in vadose zone (unsaturated) soils (EPA, 2012). SVE (also referred to as in situ soil venting or vacuum extraction) is based on mass transfer of contaminant from the solid (sorbed) and liquid (aqueous or non-aqueous) phases into the gas phase, with subsequent collection of the gas phase ...
Deep soil mixing requires specialized auger mixing equipment. In order to apply this method in-situ and in deep soil, the oxidant must be pumped to the point of mixing using a kelly bar (a piece of earth drilling equipment), or appropriate piping to the place where the soil needs to be oxidized. The soil then has to be mixed by using mixing blades.
Environmental remediation is the cleanup of hazardous substances dealing with the removal, treatment and containment of pollution or contaminants from environmental media such as soil, groundwater, sediment. [1] Remediation may be required by regulations before development of land revitalization projects.
Sand can be mixed with the reactive material to aid in allowing the water to flow through the materials. Sometimes, there will be a wall that directs the groundwater to the reactive parts of the barrier. After the trench has been filled with reactive material, soil will typically be used to cover the PRB, thus eliminating visibility from the ...
Soil map from "Geography of Ohio," 1923. A soil map is a geographical representation showing diversity of soil types or soil properties (soil pH, textures, organic matter, depths of horizons etc.) in the area of interest. [1] It is typically the result of a soil survey inventory, i.e. soil survey.
The most favorable conditions for soil nailing are as follows: The soil should be able to stand unsupported one to two meters high for a minimum of two days when cut vertical or nearly vertical. Also, all soil nails within a cross section should be located above the groundwater table. If the soil nails are not located above the groundwater ...
Soil erosion is the denudation or wearing away of the upper layer of soil. It is a form of soil degradation. This natural process is caused by the dynamic activity of erosive agents, that is, water, ice (glaciers), snow, air (wind), plants, and animals (including humans).