Ad
related to: ip addressing and subnetting workbook answers free printable chart for blood pressure
Search results
Results from the WOW.Com Content Network
Since the introduction of CIDR, however, the assignment of an IP address to a network interface requires two parameters, the address and a subnet mask. Given an IPv4 source address, its associated subnet mask, and the destination address, a router can determine whether the destination is on a locally connected network or a remote network.
Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link-local addressing. IGRP, and EIGRP are directly encapsulated in IP. EIGRP uses its own reliable transmission mechanism, while IGRP assumed an unreliable transport.
Some large / 8 blocks of IPv4 addresses, the former Class A network blocks, are assigned in whole to single organizations or related groups of organizations, either by the Internet Corporation for Assigned Names and Numbers (ICANN), through the Internet Assigned Numbers Authority (IANA), or a regional Internet registry.
Hop-by-hop is the fundamental characteristic of the IP Internet layer [1] and the OSI Network Layer. When a router interface is configured with an IP address and subnet mask, the interface becomes a host on that attached network. A directly connected network is a network that is directly attached to one of the router interfaces.
IP was the connectionless datagram service in the original Transmission Control Program introduced by Vint Cerf and Bob Kahn in 1974, which was complemented by a connection-oriented service that became the basis for the Transmission Control Protocol (TCP). The Internet protocol suite is therefore often referred to as TCP/IP.
IP addresses are described as consisting of two groups of bits in the address: the most significant bits are the network prefix, which identifies a whole network or subnet, and the least significant set forms the host identifier, which specifies a particular interface of a host on that network. This division is used as the basis of traffic ...
IP addresses are assigned to a host either dynamically as they join the network, or persistently by configuration of the host hardware or software. Persistent configuration is also known as using a static IP address. In contrast, when a computer's IP address is assigned each time it restarts, this is known as using a dynamic IP address.
The number of addresses usable for addressing specific hosts in each network is always 2 N - 2, where N is the number of rest field bits, and the subtraction of 2 adjusts for the use of the all-bits-zero host value to represent the network address and the all-bits-one host value for use as a broadcast address. Thus, for a Class C address with 8 ...
Ad
related to: ip addressing and subnetting workbook answers free printable chart for blood pressure