Ads
related to: how to test electric current with multimeter meter reading
Search results
Results from the WOW.Com Content Network
Auto-polarity for direct-current readings, shows if the electric polarity of applied voltage is positive (agrees with meter lead labels) or negative (opposite polarity to meter leads). Sample and hold, which will latch the most recent reading for examination after the instrument is removed from the circuit under test.
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.
A digital clamp meter A multimeter with built-in clamp. Pushing the large button at the bottom opens the lower jaw of the clamp, allowing the clamp to be placed around a conductor. An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp.
The indicator may be an electric light or a buzzer. [1] This led to the term "buzzing out a circuit" (which means to test for continuity) [3] Audible continuity buzzers or beepers are built into some models of multimeter, and the continuity setting is normally shared with the ohmmeter setting.
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...
They can be used to test residual-current devices because the current drawn trips most RCDs when the solenoid voltmeter is connected between the live and earth conductors. Some manufacturers include a continuity test lamp function in a solenoid meter; these use the same probes as the voltage test function.
Ammeter, e.g. Galvanometer or Milliammeter (Measures current) Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above) LCR meter - inductance (L), capacitance (C) and resistance (R) meter (measure LCR values) The following are used for stimulus of the circuit under test: Power supplies; Signal generator
In electrical engineering, current sensing is any one of several techniques used to measure electric current. The measurement of current ranges from picoamps to tens of thousands of amperes. The selection of a current sensing method depends on requirements such as magnitude, accuracy, bandwidth, robustness, cost, isolation or size. The current ...
Ads
related to: how to test electric current with multimeter meter reading