Search results
Results from the WOW.Com Content Network
The pour plate technique is the typical technique used to prepare plate count agars. Here, the inoculum is added to the molten agar before pouring the plate. The molten agar is cooled to about 45 degrees Celsius and is poured using a sterile method into a petri dish containing a specific diluted sample.
The plate count method relies on bacteria growing a colony on a nutrient medium so that the colony becomes visible to the naked eye and the number of colonies on a plate can be counted. To be effective, the dilution of the original sample must be arranged so that on average between 30 and 300 colonies of the target bacterium are grown.
The Wilhelmy plate consists of a thin plate usually on the order of a few square centimeters in area. The plate is often made from filter paper, glass or platinum which may be roughened to ensure complete wetting. In fact, the results of the experiment do not depend on the material used, as long as the material is wetted by the liquid. [1]
Colony-forming units are used to quantify results in many microbiological plating and counting methods, including: The pour plate method wherein the sample is suspended in a Petri dish using molten agar cooled to approximately 40–45 °C (just above the point of solidification to minimize heat-induced cell death).
The phage can then be isolated from the resulting plaques in a lawn of bacteria on a plate. Viral cultures are obtained from their appropriate eukaryotic host cells. The streak plate method is a way to physically separate the microbial population, and is done by spreading the inoculate back and forth with an inoculating loop over the solid agar ...
The inoculation loop is then dragged across the surface of the agar back and forth in a zigzag motion until approximately 30% of the plate has been covered. The loop then is re-sterilized and the plate is turned 90 degrees. Starting in the previously streaked section, the loop is dragged through it two to three times continuing the zigzag pattern.
Petrifilm plates have become widely used because of their cost-effectiveness, simplicity, convenience, and ease of use. For example, conventional plating would require preparing agar for pour plating, or using agar plates and vial inoculum loops for streak plating; but for Petrifilm plates, the agar is completely housed in a single unit so that ...
The plates are left upright on the bench to dry before inversion and incubation at 37 °C for 18 – 24 hours (or appropriate incubation conditions considering the organism and agar used). Each sector is observed for growth, high concentrations will give a confluent growth over the area of the drop, or a large number of small/merged colonies.