enow.com Web Search

  1. Ads

    related to: fluke cable qualification tester

Search results

  1. Results from the WOW.Com Content Network
  2. Copper cable certification - Wikipedia

    en.wikipedia.org/wiki/Copper_cable_certification

    The delay skew test is used to find the difference in propagation delay between the fastest and slowest set of wire pairs. An ideal skew is between 25 and 50 nanoseconds over a 100-meter cable. The lower this skew the better; less than 25 ns is excellent, but 45 to 50 ns is marginal.

  3. Fluke Corporation - Wikipedia

    en.wikipedia.org/wiki/Fluke_Corporation

    Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .

  4. Cable tester - Wikipedia

    en.wikipedia.org/wiki/Cable_tester

    A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...

  5. Cable fault location - Wikipedia

    en.wikipedia.org/wiki/Cable_fault_location

    The conventionally used aid in cable fault testing and location is the cable test van. The van is installed with conventional cable measuring systems for quickly reaching the location of any cable fault. In 20 years that followed, over 2000 fault location vehicles were manufactured, more than half of which were intended for the former USSR.

  6. List of IEC standards - Wikipedia

    en.wikipedia.org/wiki/List_of_IEC_standards

    IEC 60172 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires; IEC 60183 Guidance for the selection of high-voltage A.C. cable systems; IEC 60188 High-pressure mercury vapour lamps – Performance specifications; IEC 60189 Low-frequency cables and wires with PVC insulation and PVC sheath

  7. Time-domain reflectometer - Wikipedia

    en.wikipedia.org/wiki/Time-domain_reflectometer

    It is only after this round-trip delay that the short can be detected by the TDR. With knowledge of the signal propagation speed in the particular cable-under-test, the distance to the short can be measured. A similar effect occurs if the far end of the cable is an open circuit (terminated into an infinite impedance).

  1. Ads

    related to: fluke cable qualification tester