Search results
Results from the WOW.Com Content Network
The French scale, French gauge or Charrière system is commonly used to measure the size of a catheter.It is most often abbreviated as Fr, but can often be seen abbreviated as Fg, FR or F.
41.3 inches (105 cm) N/A Storm — January 12-18: 49.5 inches (126 cm) 983 hPa (29.0 inHg) Storm Category 1 February 10-13: 15.7 inches (40 cm) 956 hPa (28.2 ...
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length. For a baseline, ring size C has a circumference of 40 mm. [7]
The 46 cm (18.1 in) 46 cm/45 Type 94 naval rifle was a wire-wound gun.Mounted in three 3-gun turrets (nine per ship), they served as the main armament of the two Yamato-class battleships that were in service with the Imperial Japanese Navy during World War II.
Thus, a horse that measures 60 inches is 15 hands high (15 × 4 = 60) and a horse halfway between 15 and 16 hands is 15.2 hands, or 62 inches tall (15 × 4 + 2 = 62) [5] [7] Because the subdivision of a hand is a base 4 system, a horse 64 inches high is 16.0 hands high, not 15.4. [2]
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.