Search results
Results from the WOW.Com Content Network
Using the Smith chart, the normalised impedance may be obtained with appreciable accuracy by plotting the point representing the reflection coefficient treating the Smith chart as a polar diagram and then reading its value directly using the characteristic Smith chart scaling. This technique is a graphical alternative to substituting the values ...
Figure 1. Waveguide slotted line. Slotted lines are used for microwave measurements and consist of a movable probe inserted into a slot in a transmission line.They are used in conjunction with a microwave power source and usually, in keeping with their low-cost application, a low cost Schottky diode detector and VSWR meter rather than an expensive microwave power meter.
In electrical and electronic engineering, a current clamp, also known as current probe, is an electrical device with jaws which open to allow clamping around an electrical conductor. This allows measurement of the current in a conductor without the need to make physical contact with it, or to disconnect it for insertion through the probe.
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
Typical passive oscilloscope probe being used to test an integrated circuit. A test probe is a physical device used to connect electronic test equipment to a device under test (DUT). Test probes range from very simple, robust devices to complex probes that are sophisticated, expensive, and fragile.
By Leah Douglas and Julie Steenhuysen (Reuters) -California's public health department reported a possible case of bird flu in a child with mild respiratory symptoms on Tuesday, but said there was ...
More than one stub template may be used, if necessary, though no more than four should be used on any article. Place a stub template at the very end of the article, after the "External links" section, any navigation templates, and the category tags. As usual, templates are added by including their name inside double braces, e.g. {{Powerline-stub}}.
Black Friday tends to cause a bit of chaos every year. Especially because it’s not so much a single day of good deals as a constantly expanding period of non-stop sales (and annoying ads).