Search results
Results from the WOW.Com Content Network
A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.
A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]
The IPC is the most widely used plumbing code in the United States and is also used as the basis for the plumbing code of several other countries [citation needed].Wide adoptions are important as they help reduce manufacturer and end-user costs by allowing the use of materials across a wide user base, thus allowing economies of scale in the production of materials used in construction.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Water enters at right, fills the trap, and continues left. Inverted siphoning occurs below the line "A". Examples of traps [further explanation needed] In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste materials to pass ...
In an effort to reduce the greenhouse gas emissions that are causing climate change, the Department of Energy on proposed new energy-efficiency standards Monday for residential gas furnaces.
Revisions to the requirements for air ducts, including factory-made air ducts and dampers; New provisions for factory-built grease ducts; New provisions for refrigeration systems, including pressure-limiting devices and hydrostatic expansion; Revisions to the sizing requirements for natural gas and propane piping systems
EN 15655:2009 – Ductile iron pipes, fittings and accessories – Internal polyurethane lining for pipes and fittings – Requirements and test methods EN 877:1999/A1:2006 – Cast iron pipes and fittings, their joints and accessories for the evacuation of water from buildings – Requirements, test methods and quality assurance