Ad
related to: difference between bhp and torque converter in vehicles for sale in america
Search results
Results from the WOW.Com Content Network
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
This transmission was introduced in Europe on the 1985 Ford Scorpio and in North America with the 1985 Bronco II and Ranger, again with four- and six-cylinder engines only. It was replaced by the 4R44E and 4R55E in 1995. This was the first Ford automatic to use an EEC-controlled torque converter lock-up clutch.
This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4-cylinder Ecotec line.
Three-speed gear set with torque converter, air-cooled. Used in the Rambler American 6-cylinder cars between 1963 and 1969 as "Flash-O-Matic." Borg-Warner M40, M42, M43, and M44. 3-speed with torque converter, water-cooled. Used in AMC 6- and V8 engines between 1970 and 1971; also the 290 2-bbl V8 engine between 1967 and 1969 (M40).
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
Brake horsepower (bhp) is the power measured using a brake type (load) dynamometer at a specified location, such as the crankshaft, output shaft of the transmission, rear axle or rear wheels. [ 30 ] In Europe, the DIN 70020 standard tests the engine fitted with all ancillaries and the exhaust system as used in the car.
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
Torque Converter w/ Lockup Hydraulic 4HP 20: TBD 1995 – Transverse: TBD 4 TBD TBD S 3 2 3 Torque Converter: Hydraulic 4HP 16: TBD 2004 – 2008 Transverse: TBD 4 TBD TBD S 3 2 3 Torque Converter: Hydraulic 5HP 18: 310 N⋅m (229 lb⋅ft) 1990 – 1997 Longitudinal: 3.6648 0.7424 5 4.9363 1.4906 1.6495 S 3 3 4 Torque Converter w/ Lockup ...
Ad
related to: difference between bhp and torque converter in vehicles for sale in america