Search results
Results from the WOW.Com Content Network
The retained earnings (also known as plowback [1]) of a corporation is the accumulated net income of the corporation that is retained by the corporation at a particular point in time, such as at the end of the reporting period.
This redirected the plough's resistance into downward force on the drive wheels, which enabled Ferguson's tractor to be much lighter and more manoeuvrable than earlier models of farm tractor with equivalent tractive force and traction. As a result his tractor could operate on soft ground and caused less compacting damage to the soil in ...
A four-ox-team plough, circa 1330. The ploughman is using a mouldboard plough to cut through the heavy soils. A team could plough about one acre (0.4 ha) per day. The typical planting scheme in a three-field system was that barley, oats, or legumes would be planted in one field in spring, wheat or rye in the second field in the fall and the third field would be left fallow.
The Allen Scythe does not resemble a hand scythe but serves the same purpose. The engine drives a 2-foot-wide (0.6 m) or 3-foot-wide (0.9 m) or 4ft wide toothed blade sliding back and forth horizontally across stationary teeth to produce a scissor action, and also drives two large wheels for forward travel.
To facilitate the functioning of the water users’ organizations the State government re-ploughs 100% of the irrigation water tax collected from them. The water tax collection and plough back for O&M to water users’ organizations over the last 5 years is given in the Table below: [1] [2] [3]
Clutch-housing, gearbox and rear axle (V-Model with 5-speed gearbox) dead front axle The Porsche 218 utilises a frameless block construction. The rear axle is a live portal axle, the front axle is a dead beam axle with a central pivot point.
For premium support please call: 800-290-4726 more ways to reach us
A phenomenological uniaxial stress–strain curve showing typical work hardening plastic behavior of materials in uniaxial compression. For work hardening materials the yield stress increases with increasing plastic deformation.