Search results
Results from the WOW.Com Content Network
These are fluids typically used in the administration of intravenous therapy. Pages in category "Intravenous fluids" The following 27 pages are in this category, out of 27 total.
The most commonly used crystalloid fluid is normal saline, a solution of sodium chloride at 0.9% concentration, which is close to the concentration in the blood . [3] Ringer's lactate or Ringer's acetate is another isotonic solution often used for large-volume fluid replacement. The choice of fluids may also depend on the chemical properties of ...
Saline solution for irrigation. Normal saline (NSS, NS or N/S) is the commonly used phrase for a solution of 0.90% w/v of NaCl, 308 mOsm/L or 9.0 g per liter. Less commonly, this solution is referred to as physiological saline or isotonic saline (because it is approximately isotonic to blood serum, which makes it a physiologically normal solution).
A hypertonic solution has a greater concentration of non-permeating solutes than another solution. [2] In biology, the tonicity of a solution usually refers to its solute concentration relative to that of another solution on the opposite side of a cell membrane ; a solution outside of a cell is called hypertonic if it has a greater ...
Intravenous therapy (abbreviated as IV therapy) is a medical technique that administers fluids, medications and nutrients directly into a person's vein.The intravenous route of administration is commonly used for rehydration or to provide nutrients for those who cannot, or will not—due to reduced mental states or otherwise—consume food or water by mouth.
Hypertonic Saline which contains sodium chloride works in regulating ICP, intravascular volume and cardiac output without causing significant diuresis, but there are theoretical side effects ranging from neurological complications to subdural hematoma. Hypertonic saline solution has been choice of neuro critical care for the past few years. [1]
Gelofusine is a 4% w/v solution of succinylated gelatine (also known as modified fluid gelatine) used as an intravenous colloid, and behaves much like blood filled with albumins. [2] As a result, it causes an increase in blood volume, blood flow, cardiac output , and oxygen transportation.
A bolus intravenous dose of 10 or 20 mg of furosemide can be administered and then followed by intravenous bolus of 2 or 3% hypertonic saline to increase the serum sodium level. [12] Pulmonary edema - Slow intravenous bolus dose of 40 to 80 mg furosemide at 4 mg per minute is indicated for patients with fluid overload and pulmonary edema. Such ...