Ads
related to: rear end gears vs outer gear fluid capsspohn.net has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Spur-gear differential. A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...
While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications. The 9.5-inch C-clip rear differential was featured in both the Suburban and pickups, available in 6- or 8-lug variations, employing 33-spline axles. This differential remained in production through 2009 and even found ...
The back cone of a bevel or hypoid gear is an imaginary cone tangent to the outer ends of the teeth, with its elements perpendicular to those of the pitch cone. The surface of the gear blank at the outer ends of the teeth is customarily formed to such a back cone. [1]
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
These limited-slip differentials use helical gears, clutches or cones (an alternative type of clutch) where the engagement force of the gears or clutch is a function of the input torque applied to the differential (as the engine applies more torque the gears or clutches grip harder and Trq d increases).
This is especially important because the differential gears are bathed in heavy oil and seldom provided with any cooling besides air blowing over the housing. The impetus is to minimize overdrive use and provide a higher ratio first gear, which means more gears between the first and the last to keep the engine at its most efficient speed.
On some differentials only the high speed 2.72–3.73 carrier is used for all gear sets up to 5.89 (JK, Nissan or when thick gears are used) Axle shaft diameter 1.175" front outer (19 spline) 1.20" rear (10 spline) 1.30" rear (19 spline) 1.31" front inner (30 spline) 1.31" rear (30 spline) 1.41" rear (32 spline)
The torque tube design is typically heavier and securely ties the rear end together, thus providing a rigid rear end and assuring good alignment under all conditions. However, because of the greater unsprung weight of the torque tube and radius rods, there may be a "little hopping around of the rear end when cornering fast or on washboard roads ...
Ads
related to: rear end gears vs outer gear fluid capsspohn.net has been visited by 10K+ users in the past month