Search results
Results from the WOW.Com Content Network
By far the most common devices used in industry have a nominal resistance of 100 ohms at 0 °C and are called Pt100 sensors ("Pt" is the symbol for platinum, "100" for the resistance in ohms at 0 °C). It is also possible to get Pt1000 sensors, where 1000 is for the resistance in ohms at 0 °C.
As commonly used for commercial applications of RTD thermometers, the relationship between resistance and temperature is given by the following equations. The relationship above 0 °C (up to the melting point of aluminum ~ 660 °C) is a simplification of the equation that holds over a broader range down to -200 °C.
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
The top four seeds, as expected, were No. 1 Oregon, No. 2 Georgia, No. 3 Boise State and No. 4 Arizona State. Those teams will host the winning teams from the opening round in the quarterfinals.
A Florida Democratic congressman said that police arrested a suspect who allegedly was armed and had him on a target list near his home the day before the election.
PT100 or PT-100 may refer to: A type of the Taurus PT92 pistol; A type of resistance thermometer; Panzerfaust, a German anti-tank weapon of World War II
After going on over 30 safaris in South Africa, there are a few things I wish someone would have told me before my first one.