Search results
Results from the WOW.Com Content Network
Thus the optimum rate of twist for this bullet should be approximately 12 inches per turn. The typical twist of .30-06 caliber rifle barrels is 10 inches per turn, accommodating heavier bullets than in this example. A different twist rate often helps explain why some bullets work better in certain rifles when fired under similar conditions.
If a 5.56×45mm NATO cartridge is loaded into a chamber intended to use .223 Remington, the bullet will be in contact with the rifling and the forcing cone is very tight. This generates a much higher pressure than .223 Remington chambers are designed for. [3] NATO chose a 178-mm (1-in-7) rifling twist rate for the 5.56×45mm NATO chambering.
It also has the fastest rifling twist ratio for the .223 Remington of the three models(1:9 instead of 1:12). Early production rifles had a 1:12 twist rate and post-2014 rifles have the 1:9 twist rate. [2] The CZ 527 Varmint in .223 has muzzle velocities for standard-load 45-grain (2.9 g) ammunition of around 3,500 feet per second (1,100 m/s).
Civilian AR-15 rifles are commonly found with 1 in 12 inches (30 cm) or 54.8 calibers for older rifles and 1 in 9 inches (23 cm) or 41.1 calibers for most newer rifles, although some are made with 1 in 7 inches (18 cm) or 32 calibers twist rates, the same as used for the M16 rifle. Rifles, which generally fire longer, smaller diameter bullets ...
The K1 has 1-in-12 rifling twist for .223 Remington, while the K2 has 1-in-7.3 rifling twist for 5.56×45mm NATO. [6] The carbine version of K2 named K2C was developed and shown to the public in 2012 by SNT Motiv.
The twist of the rifling must match the intended ammunition for best accuracy. Rifling with too slow a twist will not stabilize long bullets, causing them to precess in flight; at its worst, this can result in the bullets tumbling in-flight and keyholing, where bullets strike the target sideways. Too fast a twist can also be a problem, as it ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
If the rifling is a constant twist, then the rifling rides in the grooves engraved in the bullet, and everything is secure and sealed. If the rifling has a decreasing twist, then the changing angle of the rifling in the engraved grooves of the bullet causes the rifling to become narrower than the grooves. This allows gas to blow by, and loosens ...