Search results
Results from the WOW.Com Content Network
The Ford Mustang SSP is a lightweight police car package that was based on the Ford Mustang and produced by Ford between 1982-1993. [1] The car was meant to provide a speedier option for police departments in lieu of other full sized (and heavier) sedans on the market at the time.
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
A Chevrolet Impala 9C1 displayed at the 2008 Chicago Auto Show. 9C1 is a production code used by Chevrolet to designate a vehicle intended for use as a police car or car-based emergency vehicle. 9C1-designated vehicles are marketed under the Police Pursuit Vehicle or Police Patrol Vehicle (PPV) nameplate.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
Designed for longitudinal engine configurations, the series included 4 forward gears. It was the 4-speed electronically commanded evolution of the 3-speed Turbo-Hydramatic 400, first produced in October 1963. 4L80-Es were optioned only in Chevrolet/GMC pickups, vans, and commercial vehicles, and the Hummer H1.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
As usual, the forward helical cut gears are synchronized. However, the reverse gear operates through a fully synchronized constant-mesh system. The TR-6060 contains removable wear pads on the shift forks, and uses aluminum alloys for the main case, extension housing, and clutch housing. It is a double overdrive transmission.