enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   A 37° flare type end fitting for flexible hose. The AN thread (also A-N) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.

3. Banjo fitting - Wikipedia

   en.wikipedia.org/wiki/Banjo_fitting

   Two banjo fittings (upper center of photo) atop automotive brake calipers. The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids ...

4. Braided stainless steel brake lines - Wikipedia

   en.wikipedia.org/wiki/Braided_stainless_steel...

   Since the ideal brake system would use only hard tubing for its lack of expansion, but some use of flexible hose is required, the ideal compromise is to use a hose type that allows a minimal rate of expansion. Thus the assertion that braided stainless steel hose is superior as compared to a typical rubber hose when used in a hydraulic brake system.

5. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).

6. Line lock - Wikipedia

   en.wikipedia.org/wiki/Line_lock

   Line locks can also be installed on the rear brake lines. When the line lock is activated, fluid pressure is prevented from being transferred to the rear, allowing the rear wheels to spin freely while the front brakes can be controlled with the brake pedal. This allows one to creep at varying speeds while maintaining a burnout.

7. Air-line fitting - Wikipedia

   en.wikipedia.org/wiki/Air-line_fitting

   One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.