Search results
Results from the WOW.Com Content Network
The term is also sometimes used to refer to a laced strut [2] or laced tie, structural members commonly made using a combination of structural sections connected with diagonal lacing. This form allows a strut to resist axial compression and a to resist axial tension. A lattice girder, like any girder, primarily resists bending.
These struts divide the wings into bays which are braced by diagonal wires. The flying wires run upwards and outwards from the lower wing, while the landing wires run downwards and outwards from the upper wing. The resulting combination of struts and wires is a rigid box girder-like structure independent of its fuselage mountings.
A girder (/ ˈ ɡ ɜːr d ər /) is a beam used in construction. [1] It is the main horizontal support of a structure which supports smaller beams. Girders often have an I-beam cross section composed of two load-bearing flanges separated by a stabilizing web, but may also have a box shape, Z shape, or other forms. Girders are commonly used to ...
Longerons, struts and stringers in a truss type fuselage structure [2]: 3–4 In an aircraft fuselage, stringers are attached to formers (also called frames) [3] and run in the longitudinal direction of the aircraft. They are primarily responsible for transferring the aerodynamic loads acting on the skin onto the frames and formers.
A beam is a structural element that primarily resists loads applied laterally across the beam's axis (an element designed to carry a load pushing parallel to its axis would be a strut or column). Its mode of deflection is primarily by bending , as loads produce reaction forces at the beam's support points and internal bending moments , shear ...
A solid girder or beam of equal strength would have substantial weight and material cost as compared to a truss. For a given span , a deeper truss will require less material in the chords and greater material in the verticals and diagonals.
1.3 Girder tiedown. 1.4 Joist hanger or corner bracket. 1.5 Twist strap. 1.6 Floor span connector. 1.7 Angle tie. 1.8 Z-clip. ... It is the opposite of a strut or ...
Strut is a common name in timber framing for a support or brace of scantlings lighter than a post. Frequently struts are found in roof framing from either a tie beam or a king post to a principal rafter. Struts may be vertically plumb or leaning (then called canted, raking, or angled) and may be straight or curved.