Ads
related to: intake manifold gasket leak buick
Search results
Results from the WOW.Com Content Network
To meet emissions standards, an EGR tube was placed in the intake manifold to reduce combustion temperatures. The 3800 Series II was on the Ward's 10 Best Engines list for 1995 through 1997. GM recalled 1.5 million vehicles with this engine on April 14, 2009 due to risk of fire from engine oil leaking under the valve cover gaskets onto hot ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
A redesigned cylinder head and manifold for improved air flow. Variable exhaust valve timing (the LW2 engine only had variable intake valve timing) Specially-developed fuel injectors. New pistons with pentroof-style centre-domes and valve eyelets for a higher compression ratio of 12.2:1 (compared to 10.2:1 for the dual fuel engine).
"General Motors says it will voluntarily recall nearly 1.5 million 1997 to 2003 Buick, Chevrolet, Oldsmobile and Pontiac vehicles equipped with the automaker's then-venerable 3.8-liter "Series II" V6 engine over a faulty spark plug wire retainer that could allow oil to leak onto the exhaust manifold during hard braking, thus potentially causing ...
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
It uses Sequential fuel injection, has roller tappets and features forged steel connecting rods, a one-piece cast camshaft, and either a cast aluminum or reinforced plastic intake manifold. The 3.3 has a timing chain, and is an interference engine meaning that the valves will collide with the pistons in the event of a timing chain failure.
The General Motors 60° V6 engine family is a series of 60° V6 engines produced for both longitudinal and transverse applications. All of these engines are 12-valve cam-in-block or overhead valve engines, except for the LQ1 which uses 24 valves driven by dual overhead cams.
An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1] The word manifold comes from the Old English word manigfeald (from the Anglo-Saxon manig [many] and feald [repeatedly]) and refers to the multiplying of one (pipe) into many.
Ads
related to: intake manifold gasket leak buick