enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   Collets can also be obtained to fit Morse or Brown and Sharpe taper sockets. Typically collets offer higher levels of precision and accuracy than self-centering chucks, and have a shorter setting up time than independent-jaw chucks. The penalty is that most collets can only accommodate a single size of workpiece.

4. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

5. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   The arbor of a drill chuck is often a Morse taper and this allows the chuck assembly to be removed and directly replaced with the shank of a Morse taper drill bit. A range of sleeves may be used to bring the size of the smaller Morse tapers up to the size of the drive spindle's larger taper. Sockets are also available to extend the effective ...

6. Bridgeport (machine tool brand) - Wikipedia

   en.wikipedia.org/wiki/Bridgeport_(machine_tool...

   Machine tapers for tool holding included Morse tapers (on early models) and the R8 taper (a widely used standard that Bridgeport created) on most models. Both Morse and R8 allowed for both collets and solid holders, and a drill chuck could be held by either of the latter. Currently R8 and Erickson #30 Quick Change tool holders are available.

7. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   No. 3 morse taper reamer. A morse taper reamer is used manually to finish morse taper sleeves. These sleeves are a tool used to hold machine cutting tools or holders in the spindles of machines such as a drill or milling machine. The reamer shown is a finishing reamer.

8. Metal lathe - Wikipedia

   en.wikipedia.org/wiki/Metal_lathe

   The spindle runs in precision bearings and is fitted with some means of attaching workholding devices such as chucks or faceplates. This end of the spindle usually also has an included taper, frequently a Morse taper, to allow the insertion of hollow tubular (Morse standard) tapers to reduce the size of the tapered hole, and permit use of centers.

9. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   The number refers to the Association for Manufacturing Technology (formerly the National Machine Tool Builders Association (NMTB)) taper size of the tool. A CAT-40 toolholder A boring head on a Morse taper shank. An improvement on CAT Tooling is Bridgeport Taper (BT) Tooling, which looks similar and can easily be confused with CAT tooling.