Search results
Results from the WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
Template talk:Convert • Questions on using the convert template, or discussion of any problems encountered, or proposals to add units or change convert Wikipedia:Help desk • General questions Module talk:Convert • Discussion concerning the convert modules (however, discussions relating to units should occur at Template talk:Convert )
Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [2] For example, a catheter with a French size of 9 would have an outer diameter of approximately 3 mm. While the French scale aligns closely with the metric system, it introduces redundancy and the potential for rounding errors.
The English word "inch" (Old English: ynce) was an early borrowing from Latin uncia ("one-twelfth; Roman inch; Roman ounce"). [2] The vowel change from Latin /u/ to Old English /y/ (which became Modern English /ɪ/) is known as umlaut. [citation needed] The consonant change from the Latin /k/ (spelled c) to English /tʃ/ is palatalisation.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
In the SI system and generally in older metric systems, multiples and fractions of a unit can be described via a prefix on a unit name that implies a decimal (base-10), multiplicative factor. The only exceptions are for the SI-accepted units of time (minute and hour) and angle (degree, arcminute, arcsecond) which, based on ancient convention ...
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...
He did not change the subdivisions (1 inch = 12 subdivisions = 72 points), but defined it strictly in terms of the royal foot, a legal length measure in France: the Didot point is exactly 1 ⁄ 864 of a French foot or 1 ⁄ 72 of a French inch, that is (by 1799) 15 625 ⁄ 41 559 mm or about 0.375 972 mm. Accordingly, one Didot point is exactly ...