Search results
Results from the WOW.Com Content Network
A hoist controller is the controller for a hoist. The term is used primarily in the context of electrically operated hoists, but it is apparent that the control systems of many 20th century steam hoists also incorporated controllers of significant complexity. Consider the control system of the Quincy Mine No. 2 Hoist. [1]
Yamaha also announced that same day that the company was temporarily suspending sales of the Rhino until the affected models could be repaired, and the CPSC advised owners not to operate the vehicles until taking them to a dealership for the modifications. All subsequent Rhino 450, 660 and 700 models have the same modifications.
Hoist atop an elevator. A hoist is a device used for lifting or lowering a load by means of a drum or lift-wheel around which rope or chain wraps. It may be manually operated, electrically or pneumatically driven and may use chain, fiber or wire rope as its lifting medium.
Such systems operate between 4,000 to 5,800 psi (28,000 to 40,000 kPa). The North American market developed low pressure / high volume systems, which allowed operators to share the hoist's hydraulic system with other hydraulically powered devices. These systems typically operate with a larger gear pump and larger hydraulic reservoir. Operating ...
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
An electronic speed control follows a speed reference signal (derived from a throttle lever, joystick, or other manual input) and varies the switching rate of a network of field effect transistors (FETs). [1] By adjusting the duty cycle or switching frequency of the transistors, the speed of the motor is changed. The rapid switching of the ...
1910 "New Pattern' James with hub-center steering Detail of mechanism on the Mead & Tomkinson Kawasaki 'Nessie' Steven Linsdell's Yamaha GTS Isle of Man TT racing motorcycle The hub-center steer concept is a very old one used as early as 1910 by the British James Cycle Co , and in 1920 by Ner-a-Car , and enjoyed an aftermarket vogue in the ...