enow.com Web Search

  1. Ads

    related to: 1 3/8 socket 1/2 drive drive dur sae socket bits

Search results

  1. Results from the WOW.Com Content Network
  2. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    The internal-drive square socket for screws (as well as the corresponding triangular socket drive) had been conceived several decades before the invention of the Robertson screw and driver. An earlier patent covering both square-socket- and triangle-socket -drive wood screws, U.S. patent 161,390 , was issued to Allan Cummings of New York City ...

  3. Socket wrench - Wikipedia

    en.wikipedia.org/wiki/Socket_wrench

    Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 38-inch and 12-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 38-inch drives some ratchets can be used with ...

  4. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    A security Torx screw drive is a common modification to socket and cruciform style drives to make the fastener more tamper resistant by inserting a pin in the center of the female socket, requiring a tool with a corresponding hole to drive the fastener. This can also prevent attempts at turning the screw with a small flat-bladed screwdriver.

  5. These Standardized Socket Sets Make Short Work of Auto and ...

    www.aol.com/lifestyle/standardized-socket-sets...

    For premium support please call: 800-290-4726 more ways to reach us

  6. Torx - Wikipedia

    en.wikipedia.org/wiki/Torx

    A security Torx L-key and fastener with holes for a safety pin to hinder disassembly with an ordinary Torx key. A Torx T8 screw head on a hard disk drive.. Torx (pronounced / t ɔːr k s /) is a trademark for a type of screw drive characterized by a 6-point star-shaped pattern, developed in 1967 [1] by Camcar Textron.

  7. Tap and die - Wikipedia

    en.wikipedia.org/wiki/Tap_and_die

    where is the tap drill size, is the major diameter of the tap (e.g., 38 in for a 38-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 38-16 tap). For a 38-16 tap, the above formula would produce 5 ⁄ 16, which is the correct tap drill diameter. The above formula ultimately results in an approximate 75% thread.

  1. Ads

    related to: 1 3/8 socket 1/2 drive drive dur sae socket bits