Search results
Results from the WOW.Com Content Network
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels. The distinction can be arbitrary between a computer bus, often closer in space, and larger telecommunications networks.
Bus (computing), a communication system that transfers data between different components in a computer or between different computers Memory bus, a bus between the computer and the memory; PCI bus, a bus between motherboard and peripherals that uses the Peripheral Component Interconnect standard
Between data frames, the bus controller holds SCL high, in effect stopping the clock, and SDA drivers are in a high-impedance state, permitting a pull-up resistor to float it to high. A high-to-low transition of SDA while SCL is high is known as a START symbol, and signals the beginning a new data frame.
ARINC 429 utilizes a unidirectional bus with a single transmitter and up to twenty receivers. A data word consists of 32 bits communicated over a twisted pair cable using the bipolar return-to-zero modulation. There are two speeds of transmission: high speed operates at 100 kbit/s and low speed operates at 12.5 kbit/s.
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
ARINC 429, [1] the "Mark 33 Digital Information Transfer System (DITS)," is the ARINC technical standard for the predominant avionics data bus used on most higher-end commercial and transport aircraft. [2] It defines the physical and electrical interfaces of a two-wire data bus and a data protocol to support an aircraft's avionics local area ...
An asynchronous control bus used to access memory-mapped I/O registers in the individual storage devices, [1]: 8.0 and; A high-speed, synchronous data bus that is used to carry the actual data transfers between the storage devices and the host bus adapter. [1]: 8.0 The data bus is 18 bits wide plus parity. [1]: 34.0