Search results
Results from the WOW.Com Content Network
Replacing a cylindrical fuel tank with a D-Tank can result in 46% additional fuel capacity. When calculating volume requirements, one would begin by assessing the available space. Once length, width and height restrictions have been ascertained, the easiest method of determining volume is with the use of a truck tank volume calculator.
For energy storage, the energy density relates the stored energy to the volume of the storage equipment, e.g. the fuel tank. The higher the energy density of the fuel, the more energy may be stored or transported for the same amount of volume. The energy of a fuel per unit mass is called its specific energy.
Current volume of a product stored in a tank can be calculated using a tank capacity table (sometimes called "tank calibration table") and current levels and temperatures of a product in a tank. Tank capacity table stores data about level and appropriate volume in a tank and have a very high impact on overall accuracy of volume calculation.
A fuel tank (also called a petrol tank or gas tank) is a safe container for flammable fluids, often gasoline or diesel fuel. Though any storage tank for fuel may be so called, the term is typically applied to part of an engine system in which the fuel is stored and propelled ( fuel pump ) or released (pressurized gas) into an engine .
One GGE of natural gas is 126.67 cubic feet (3.587 m 3) at standard conditions. This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22]
Boyle's law is a gas law, stating that the pressure and volume of a gas have an inverse relationship. If volume increases, then pressure decreases and vice versa, when the temperature is held constant. Therefore, when the volume is halved, the pressure is doubled; and if the volume is doubled, the pressure is halved.
The AGA 7 calculation itself is a simple ratio and is, in essence, a density correction approach to translating the volume or rate of gas at flowing conditions to a volume or rate at base conditions. Orifice meters are a very commonly used type of meter, and because of their widespread use, the characteristics of gas flow through an orifice ...
The quantity Q could be mass or energy as well as volume. The allocation calculations are carried out per phase, for example oil, gas and water respectively. Example with calculations to illustrate the principle of proportional allocation. Assume that the flows of separated oil from two production units go to a common storage tank.