Search results
Results from the WOW.Com Content Network
A permanent magnet synchronous motor and reluctance motor requires a control system for operating (VFD or servo drive). There is a large number of control methods for synchronous machines, selected depending on the construction of the electric motor and the scope. Control methods can be divided into: [21] [22] Scalar control. V/f control ...
In electrical engineering, the Korndorfer starter is a technique used for reduced voltage soft starting of induction motors. The circuit uses a three-phase autotransformer and three three-phase switches. This motor starting method has been updated and improved by Hilton Raymond Bacon. [1]
The circle diagram can be drawn for alternators, synchronous motors, transformers, induction motors. The Heyland diagram is an approximate representation of a circle diagram applied to induction motors, which assumes that stator input voltage, rotor resistance and rotor reactance are constant and stator resistance and core loss are zero.
A motor soft starter is a device used with AC electrical motors to temporarily reduce the load and torque in the powertrain and electric current surge of the motor during start-up. This reduces the mechanical stress on the motor and shaft, as well as the electrodynamic stresses on the attached power cables and electrical distribution network ...
In vector control, an AC induction or synchronous motor is controlled under all operating conditions like a separately excited DC motor. [21] That is, the AC motor behaves like a DC motor in which the field flux linkage and armature flux linkage created by the respective field and armature (or torque component) currents are orthogonally aligned such that, when torque is controlled, the field ...
The synchronous reactances are exhibited by the armature in the steady-state operation of the machine. [8] The three-phase system is viewed as a superposition of two: the direct one, where the maximum of the phase current is reached when the pole is oriented towards the winding and the quadrature one, that is 90° offset.
In the grid side converter DTC version the grid is considered to be a big electric machine. DTC techniques for the interior permanent magnet synchronous machine (IPMSM) were introduced in the late 1990s [16] and synchronous reluctance motors (SynRM) in the 2010s. [17] DTC was applied to doubly fed machine control in the early 2000s. [18]
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.