Search results
Results from the WOW.Com Content Network
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
British Airways Flight 38 crash-landed at London Heathrow in 2008 after its fuel lines became clogged with ice crystals.. In an internal combustion engine, fuel starvation is the failure of the fuel system to supply sufficient fuel to allow the engine to run properly, for example due to blockage, vapor lock, contamination by water, malfunction of the fuel pump or incorrect operation, leading ...
Oil sludge or black sludge is a gel-like or semi-solid deposit inside an internal combustion engine, that can create a catastrophic buildup. It is often the result of contaminated engine oil and occurs when moisture and/or high heat is introduced to engine oil.
The oil pressure idiot light lights when engine oil pressure drops below a predetermined level. The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running ...
Crankcase dilution occurs when the fuel oil from the engine gets into the lube oil of the engine. This can be caused by the walls being wetted due to the fuel condensing in the cylinder. If the engine is cold, or there is an excess amount of cooling around the cylinder, [ 1 ] the fuel oil will condense and have a higher chance to end up in the ...
The tanks, at a combined cost of nearly $400 million, will allow We Energies to buy and store large amounts of natural gas when prices are low and release the gas as needed, alleviating some of ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...