enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flow table test - Wikipedia

   en.wikipedia.org/wiki/Flow_table_test

   The flow table test or slump-flow test is a method to determine consistency of fresh concrete. Flow table test is also used to identify transportable moisture limit of solid bulk cargoes. [ 1 ] It is used primarily for assessing concrete that is too fluid (workable) to be measured using the slump test , because the concrete will not retain its ...

3. Epoxy moisture control system - Wikipedia

   en.wikipedia.org/wiki/Epoxy_moisture_control_system

   Epoxy moisture control systems can be applied over concrete with relative humidity levels up to 100%, and there are systems available on the market today that can be applied over concrete that is physically damp. In some cases, with the use of an epoxy moisture control system, floor coverings can be installed just 7 days after the slab is poured.

4. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   Depending on the FBE coating system, full cure can be achieved in less than one minute to few minutes in case of long cure FBE's, which are used for internal pipe coating applications. Rebars are coated in a similar manner as coating application, on the exterior of pipes. For FBE coating application on the interior of pipe surface, a lance is used.

5. Polished concrete - Wikipedia

   en.wikipedia.org/wiki/Polished_concrete

   Polished concrete may be considered a form of sustainable design flooring, if less material is used than in comparable types of flooring. [citation needed] Polished concrete floors have the following advantages: low-maintenance [7] – polished concrete is easily maintained with the use of clean water or a neutral pH cleaner. The application of ...

6. Impervious surface - Wikipedia

   en.wikipedia.org/wiki/Impervious_surface

   Parking lots are highly impervious.. Impervious surfaces are mainly artificial structures—such as pavements (roads, sidewalks, driveways and parking lots, as well as industrial areas such as airports, ports and logistics and distribution centres, all of which use considerable paved areas) that are covered by water-resistant materials such as asphalt, concrete, brick, stone—and rooftops.

7. Electrical resistivity measurement of concrete - Wikipedia

   en.wikipedia.org/wiki/Electrical_resistivity...

   The rate of flow of the ions between the anode and cathode areas, and therefore the rate at which corrosion can occur, is affected by the resistivity of the concrete. [5] To measure the electrical resistivity of the concrete a current is applied to the two outer probes and the potential difference is measured between the two inner probes.

8. Passive solar building design - Wikipedia

   en.wikipedia.org/wiki/Passive_solar_building_design

   The temperature variations caused by the heat losses and gains can be moderated by thermal mass and low-emissivity windows. Thermal mass can include a masonry floor, a masonry wall bordering the house, or water containers. Distribution of heat to the building can be accomplished through ceiling and floor level vents, windows, doors, or fans.

9. Decorative concrete - Wikipedia

   en.wikipedia.org/wiki/Decorative_concrete

   Exposed aggregate concrete is a popular decorative concrete option known for its decorative gravel appearance. During the concrete pouring process, the top layer of cement/sand paste is removed to reveal the embedded aggregate (stones, pebbles, or even shells). This creates a visually appealing surface with a variety of colors, shapes, and sizes.