Search results
Results from the WOW.Com Content Network
AlSi10Mg is a lightweight, high-strength aluminium alloy that is widely used in the aerospace, automotive, and medical industries. Its unique combination of aluminium , silicon , and magnesium makes it an ideal material for additive manufacturing processes, such as 3D printing .
The exact properties depend on whether the composition of the alloy is above, near or below the eutectic point. Castability increases with increasing Si content and is best at about 17% Si; the mechanical properties are best at 6% to 12% Si. The mold filling capacity reaches its maximum at 12% Si, but is also good with other contents.
2 Density, liquid phase. 3 Density, gas phase. 4 Notes. 5 See also. ... The suggested values for liquid densities refer to "at the melting point (m.p.)" by default.
The Gmelin rare earths handbook lists 1522 °C and 1550 °C as two melting points given in the literature, the most recent reference [Handbook on the chemistry and physics of rare earths, vol.12 (1989)] is given with 1529 °C.
A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%).
Its predicted melting and boiling points are 52±15 °C and 177±10 °C respectively, so that it is probably neither noble nor a gas; it is expected to have a density of about 6.6–7.4 g/cm 3 around room temperature. It is expected to have a barely positive electron affinity (estimated as 5 kJ/mol) and a moderate ionisation energy of about 860 ...
The melting point (or, rarely, liquefaction point) of a substance is the temperature at which it changes state from solid to liquid. At the melting point the solid and liquid phase exist in equilibrium. The melting point of a substance depends on pressure and is usually specified at a standard pressure such as 1 atmosphere or 100 kPa.
Latent heat storage can be achieved through changes in the state of matter from liquid→solid, solid→liquid, solid→gas and liquid→gas. However, only solid→liquid and liquid→solid phase changes are practical for PCMs. Although liquid–gas transitions have a higher heat of transformation than solid–liquid transitions, liquid→gas ...