Search results
Results from the WOW.Com Content Network
The LB1 used in trucks and vans was referred to as Vortec in Chevrolet literature (named after a combustion chamber design known as a swirl port which twists the fuel mix from the intake ports as introduced with the Cavalier's 2.0L engine), and this name continued to be used with all truck and van 4.3 L (262 cu in) V6s until 2014.
Vortec is a trademarked name for a line of gasoline engines for General Motors trucks. The name first appeared in an advertisement for the 1985 model year 4.3 L V6 that used "vortex technology" to create a vortex inside the combustion chamber , creating a better air / fuel atomization. [ 1 ]
The LLV (also called Vortec 2900) is a 2.9 L; 178.3 cu in (2,921 cc) straight-4 DOHC engine produced between 2007 and 2012, with a 95.5 mm × 102 mm (3.76 in × 4.02 in) bore and a stroke. It replaced the LK5 and produced 185 hp (138 kW) at 5,600 rpm and 190 lb⋅ft (258 N⋅m) of torque at 2,800 rpm.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The engine is a modified version of the Vortec engine found in the standard Jimmy, which originally produced 190 hp (142 kW). [2] The engine uses a Mitsubishi TD06-17C/8 cm 2 turbocharger producing 14 psi (0.97 bar) of boost and a Garrett Water/Air intercooler , as well as revised intake manifolds , fuel system, exhaust manifolds, and a 48 mm ...
The 267 was introduced in 1979 for the GM F-body (Camaro), G-body (Chevrolet Monte Carlo, El Camino), A-body (Malibu Classic, 1979–1981) and also used on GM B-body cars (Impala and Caprice models). The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88 ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
GM's Active Fuel Management [2] technology used a solenoid to deactivate the lifters on selected cylinders of a pushrod V-layout engine. GM used the Active Fuel Management technology on a range of engines including with the GM Small Block Gen IV engine family, first-generation GM EcoTec3 engine family, second-generation GM High-Feature V6 DOHC ...