Search results
Results from the WOW.Com Content Network
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
ATX12VO power supply connector Color Signal Pin Pin Signal Color Green PS_ON# 1 6 PWR_OK: Gray Black COM 2 7 +12 VSB Purple Black COM 3 8 +12 V1 DC Yellow Black COM 4 9 +12 V1 DC Yellow TBD Reserved 5 10 +12 V1 DC Voltage Sensing Pin Yellow
PS_ON# (power on) is a signal from the motherboard to the power supply. When the line is connected to ground (by the motherboard), the power supply turns on. It is internally pulled up to +5 V inside the power supply. [3] [19] PWR_OK ("power good") is an output from the power supply that indicates that its output has stabilized and is ready for ...
Entry-Level Power Supply Specification (EPS) is a power supply unit meant for high-power-consumption computers and entry-level servers. Developed by the Server System Infrastructure (SSI) forum, a group of companies including Intel, Dell, Hewlett-Packard and others, that works on server standards, the EPS form factor is a derivative of the ATX ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
One of the issues with using an RC network to generate a PoR pulse is the sensitivity of the R and C values to the power-supply ramp characteristics. When the power supply ramp is rapid, the R and C values can be calculated so that the time to reach the switching threshold of the Schmitt trigger is enough to apply a long enough reset pulse ...
Power supply may be bad Long continuous beep tone Memory failure Steady, long beeps Power supply bad No beep Power supply bad, system not plugged in, or power not turned on No beep If everything seems to be functioning correctly there may be a problem with the 'beeper' itself. The system will normally beep one short beep. One long, two short beeps
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...