enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Jigsaw (tool) - Wikipedia

   en.wikipedia.org/wiki/Jigsaw_(tool)

   Control is an issue with jigsaws; the blades are small and weak, with the lower end entirely unsupported. Good cut control requires the presence of blade rollers, which keep the blade aligned just above the sole plate. In addition, heavy-cast sole plate saws are somewhat better than pressed steel for sawing line control.

3. Marking knife - Wikipedia

   en.wikipedia.org/wiki/Marking_knife

   The blades on marking knives are made of tool steel, have either a skewed end or a spear point, and the knife edge is bevelled on either one side of the blade or both sides. [4] On single-bevel skewed knives the side of the blade that is bevelled dictates whether the knife is for left-handed or right-handed use, while single-bevel spear point ...

4. Riving knife - Wikipedia

   en.wikipedia.org/wiki/Riving_knife

   Saw blade "grabbing" occurs more frequently during ripping than cross-cutting (cuts made to wood or stone across its main grain or axis). It can occur with both hand saws and bandsaws but is more dangerous with a circular saw as areas of the circular blade close to the cutting area are moving in different directions. If a bandsaw grabs, the ...

5. Biscuit joiner - Wikipedia

   en.wikipedia.org/wiki/Biscuit_joiner

   A biscuit joiner or biscuit jointer (or sometimes plate joiner) is a woodworking tool used to join two pieces of wood together. A biscuit joiner uses a small circular saw blade to cut a crescent-shaped hole (called the mouth) in the opposite edges of two pieces of wood or wood composite panels .

6. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   The sole plate is then either rested flat on the workpiece overhanging the edge so that the cutting bit is not contacting the work (and then entering the work from the side once the motor is turned on), or the sole plate is placed at an angle with the bit above the work and the bit is "rocked" over into the work once the motor is turned on.

7. Square (tool) - Wikipedia

   en.wikipedia.org/wiki/Square_(tool)

   Made with a thin steel blade fixed at 90° into a thicker stock that is typically made of wood. The inside face of the stock is sometimes faced with brass to reduce wear. Historically woodworkers would often make their own try squares out of wood. The top of the stock is sometimes at a 45° angle so the square can also be used as a mitre square.

8. AOL

   search.aol.com

   The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.

9. Jig (tool) - Wikipedia

   en.wikipedia.org/wiki/Jig_(tool)

   A jig used in making jewelry, a specific type of jig, is a plate or open frame for holding work and helping to shape jewelry components made out of wire or small sheets of metal. A jig in the jewelry making application is used to help establish a pattern for use in shaping the wire or sheets of metal.