Search results
Results from the WOW.Com Content Network
MediaWiki stores rendered formulas in a cache so that the images of those formulas do not need to be created each time the page is opened by a user. To force the rerendering of all formulas of a page, you must open it with the getter variables action=purge&mathpurge=true. Imagine for example there is a wrong rendered formula in the article Integral
In fluid dynamics, normalized root mean square deviation (NRMSD), coefficient of variation (CV), and percent RMS are used to quantify the uniformity of flow behavior such as velocity profile, temperature distribution, or gas species concentration. The value is compared to industry standards to optimize the design of flow and thermal equipment ...
Another type of normalization is based on a measure of loudness, wherein the gain is changed to bring the average loudness to a target level. This average may be approximate, such as a simple measurement of average power (e.g. RMS), or more accurate, such as a measure that addresses human perception e.g. that defined by EBU R128 and offered by ReplayGain, Sound Check and GoldWave.
The human ear responds quite differently to clicks and bursts of random noise, and it is this difference that gave rise to the CCIR-468 weighting curve (now supported as an ITU standard), which together with quasi-peak measurement (rather than the rms measurement used with A-weighting) became widely used by broadcasters throughout Britain ...
Peak values can be calculated from RMS values from the above formula, which implies V P = V RMS × √ 2, assuming the source is a pure sine wave. Thus the peak value of the mains voltage in the USA is about 120 × √ 2, or about 170 volts. The peak-to-peak voltage, being double this, is about 340 volts.
In telecommunications, the delay spread is a measure of the multipath richness of a communications channel. In general, it can be interpreted as the difference between the time of arrival of the earliest significant multipath component (typically the line-of-sight component) and the time of arrival of the last multipath components.
The unit dB FS or dBFS is defined in AES Standard AES17-1998, [13] IEC 61606, [14] and ITU-T Recs. P.381 [15] and P.382, [16] such that the RMS value of a full-scale sine wave is designated 0 dB FS. This means a full-scale square wave would have an RMS value of +3 dB FS.
In the above formula, P is measured in units of power, such as watts (W) or milliwatts (mW), and the signal-to-noise ratio is a pure number. However, when the signal and noise are measured in volts (V) or amperes (A), which are measures of amplitude, [ note 1 ] they must first be squared to obtain a quantity proportional to power, as shown below: