Search results
Results from the WOW.Com Content Network
In generic terms, a stick pusher is known as a stall identification device or stall identification system. [73] A stick shaker is a mechanical device that shakes the pilot's controls to warn of the onset of stall. A stall warning is an electronic or mechanical device that sounds an audible warning as the stall speed is approached. The majority ...
The effect of airfoil geometry on dynamic stall is quite intricate. As is shown in the figure, for a cambered airfoil, the lift stall is delayed and the maximum nose-down pitch moment is significantly reduced. On the other hand, the inception of stall is more abrupt for a sharp leading-edge airfoil. [8] More information is available here. [13]
On aircraft with swept wings, wing tip stall also produces an undesirable nose-up pitching moment which hampers recovery from the stall. Washout may be accomplished by other means e.g. modified aerofoil section, vortex generators, leading edge wing fences, notches, or stall strips. This is referred to as aerodynamic washout.
The design configuration arrived at in the conceptual design phase is then tweaked and remodeled to fit into the design parameters. In this phase, wind tunnel testing and computational fluid dynamic calculations of the flow field around the aircraft are done. Major structural and control analysis is also carried out in this phase. Aerodynamic ...
A stick shaker is a mechanical device designed to rapidly and noisily vibrate the control yoke (the "stick") of an aircraft, warning the flight crew that an imminent aerodynamic stall has been detected. It is typically present on the majority of large civil jet aircraft, as well as most large military planes.
A compressor stall is a local disruption of the airflow in the compressor of a gas turbine or turbocharger. A stall that results in the complete disruption of the airflow through the compressor is referred to as a compressor surge. The severity of the phenomenon ranges from a momentary power drop barely registered by the engine instruments to a ...
The engineering design process, also known as the engineering method, is a common series of steps that engineers use in creating functional products and processes. The process is highly iterative – parts of the process often need to be repeated many times before another can be entered – though the part(s) that get iterated and the number of such cycles in any given project may vary.
The wind frame is a convenient frame to express the aerodynamic forces and moments acting on an aircraft. In particular, the net aerodynamic force can be divided into components along the wind frame axes, with the drag force in the −x w direction and the lift force in the −z w direction. Mnemonics to remember angle names