Search results
Results from the WOW.Com Content Network
Similarly, a processing circuitry inside a multi-core processor can transfer data to and from its local memory without occupying its processor time, allowing computation and data transfer to proceed in parallel. DMA can also be used for "memory to memory" copying or moving of data within memory. DMA can offload expensive memory operations, such ...
The Word DMA (WDMA) interface was the fastest method used to transfer data between the computer (through the Advanced Technology Attachment (ATA) controller) and an ATA device until Ultra Direct Memory Access (UDMA) was implemented.
In computing, remote direct memory access (RDMA) is a direct memory access from the memory of one computer into that of another without involving either one's operating system. This permits high-throughput, low- latency networking, which is especially useful in massively parallel computer clusters .
The Ultra DMA (Ultra Direct Memory Access, UDMA) modes are the fastest methods used to transfer data through the ATA hard disk interface, usually between a computer and an ATA device. UDMA succeeded Single / Multiword DMA as the interface of choice between ATA devices and the computer.
A GART is used as a means of data exchange between the main memory and video memory through which buffers (i.e. paging/swapping) of textures, polygon meshes and other data are loaded, but can also be used to expand the amount of video memory available for systems with only integrated or shared graphics (i.e. no discrete or inbuilt graphics ...
Intel 8237A-5, used on the original IBM PC motherboard Pinout. Intel 8237 is a direct memory access (DMA) controller, a part of the MCS 85 microprocessor family. It enables data transfer between memory and the I/O with reduced load on the system's main processor by providing the memory with control signals and memory address information during the DMA transfer.
In computing, bus mastering is a feature supported by many bus architectures that enables a device connected to the bus to initiate direct memory access (DMA) transactions. It is also referred to as first-party DMA, in contrast with third-party DMA where a system DMA controller actually does the transfer.
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.