enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Ducts for air pollution control in a 17000 standard cubic feet per minute regenerative thermal oxidizer (RTO). A round galvanized steel duct connecting to a typical diffuser Fire-resistance rated mechanical shaft with HVAC sheet metal ducting and copper piping, as well as "HOW" (Head-Of-Wall) joint between top of concrete block wall and underside of concrete slab, firestopped with ceramic ...

3. Register (air and heating) - Wikipedia

   en.wikipedia.org/wiki/Register_(air_and_heating)

   If not properly installed and tightly connected to the ductwork, air will spill around the register and greatly reduce the HVAC system's efficiency. [5] Ideally, a room will have both heating and cooling registers. In practice, cost considerations usually require that heating and cooling be provided by the same register.

4. Uniform Mechanical Code - Wikipedia

   en.wikipedia.org/wiki/Uniform_Mechanical_Code

   The Uniform Mechanical Code (UMC) is a model code developed by the International Association of Plumbing and Mechanical Officials to govern the installation, inspection and maintenance of HVAC (heating, ventilating and air-conditioning) and refrigeration systems. It is designated as an American National Standard.

5. Mechanical systems drawing - Wikipedia

   en.wikipedia.org/wiki/Mechanical_systems_drawing

   Mechanical systems drawing is a type of technical drawing that shows information about heating, ventilating, air conditioning and transportation around the building (Elevators or Lifts and Escalator). [1] It is a powerful tool that helps analyze complex systems.

6. Underfloor air distribution - Wikipedia

   en.wikipedia.org/wiki/Underfloor_air_distribution

   Conventional overhead mixing systems usually locate both the supply and return air ducts at the ceiling level. Supply air is supplied at velocities higher than typically acceptable for human comfort and the air temperature may be lower, higher, or the same as desired room temperature depending on the cooling/heating load.

7. Ductwork airtightness - Wikipedia

   en.wikipedia.org/wiki/Ductwork_airtightness

   The ductwork airtightness level is the airflow rate through ductwork leakages divided by the ductwork area. It is recommended to test at least 10% and 10 m 2 of the duct surface including all duct types and a variety of sizes and components. The ductwork surface area is estimated according to EN 14239. [11]