Search results
Results from the WOW.Com Content Network
The noise power at the output of the amplifier (i.e. the noise power coupled to an impedance-matched load that is connected to the amplifier output) is P out = Gk B (T R + T amp)B, where G is the amplifier power gain, and T amp is the amplifier noise temperature. In the Y-factor technique, P out is measured for two different, known values of T R.
One way to perform the measurement is described on the Y-factor page. A noise-figure meter could automate that procedure as follows: A gated broadband noise source (such as an avalanche diode) drives the device under test. A measurement is made with the noise source on; another measurement with the noise source off.
Noise figure (NF) and noise factor (F) are figures of merit that indicate degradation of the signal-to-noise ratio (SNR) that is caused by components in a signal chain.These figures of merit are used to evaluate the performance of an amplifier or a radio receiver, with lower values indicating better performance.
The Y-factor method is a common measurement technique for this purpose. [1] By using a noise diode, the output noise of an amplifier is measured using two input noise levels, and by measuring the output noise factor (referred to as Y) the noise figure of the amplifier can be determined without having to measure the amplifier gain.
The noise factor (a linear term) is more often expressed as the noise figure (in decibels) using the conversion: = The noise figure can also be seen as the decrease in signal-to-noise ratio (SNR) caused by passing a signal through a system if the original signal had a noise temperature of 290 K. This is a common way of expressing the noise ...
This is a measure of how much noise is introduced in the amplification process. Noise is an undesirable but inevitable product of the electronic devices and components; also, much noise results from intentional economies of manufacture and design time. The metric for noise performance of a circuit is noise figure or noise factor. Noise figure ...
Noise measurement can also be part of a test procedure using white noise, or some other specialized form of test signal.In audio systems and broadcasting, specific methods are used to obtain subjectively valid results in order that different devices and signal paths may be compared regardless of the inconsistent spectral distribution and temporal properties of the noise that they generate.
A major use of noise weighting is in the measurement of residual noise in audio equipment, usually present as hiss or hum in quiet moments of programme material. The purpose of weighting here is to emphasise the parts of the audible spectrum that ears perceive most readily, and attenuate the parts that contribute less to perception of loudness, in order to get a measured figure that correlates ...